Hello friends

Today I would like to share to everyone the GX-Works2 V1.560J software which is the latest version

Although Mitsubishi has now released GX-Works3 software, but if you do not need to use FX5U PLC programming, this GX-Works2 software is sufficient and its advantage is that the configuration requirement is much lower than that of GX -Works3

GX-Works2 is a software upgraded and replaced by Mitsubishi for GX Developer with a nicer visual interface, smooth operation and support for other programming languages ​​such as FBD (Function Block Diagram), SFC. (Sequential Function Chart)

Programmable software for Mitsubishi PLC series FX0S, FX0, FX1, FX1S, FX1N, FX1NC, FX2N, FX2NC, FX3S, FX3G, FXGC, FX3U, FX3UC, Q-CPU Series (Q mode, A mode), L-CPU, QS-CPU, QnA-CPU, A-CPU, S-CPU, CNC

• Video for installing software (Link Download the bottom of the article)
• Installation instructions for images :

+ Step 1 : Download GX-Works2 software and extract it

+ Step 2 : Go to GX Works2 Version 1.560J folder

+ 3 : Run the setup file and select OK

+ 4 : Choose Next

+ 5 : Open the ReadMe file to get the Key

+ 6 : Enter user information and Product ID

+ 7 : You can choose whether or not to install additional GX-Developer software

+ 8 : Choose Destination Location

+ 9 : Click Next to begin installing the software

+ 10 : Wait for the installation process to take about 15 minutes

+ 11 : The installation process is successful, select Finish

Open the software and work with it

>>>Link Download Software (Google Drive – High Speed Download) :

If there are any problems during the installation process please comment below the post
Thanks for visiting website ^^